Software

"Configurator" may be used for testing, configuration, calibration, data analysis, optimization and graduation devices. The program supports the following device: BOP; UDA-1AB; UDG-1B; BOP-1S; BOP-1M, DKG-09D.
With the help of the "Configurer" you can read the information about the internal state of the device, display information about possible errors and failures in his work, tune individual settings or switch his mode of operation. In addition, you can delete archived data measurements and workers spectra for further analysis.
Version: 1.9.6.250.

UMF-2000 software (ver. 2.0) for Win 98/NT/2000/XP/7/10

For Windows 2000, XP, Vista, 7. x86 and x64.

Windows XP driver for USB to Serial Adapter for Unfors Xi. Provides a fully functional RS-232 via USB interface.

The program "TETRA_Tester" focused primarily on the automation of routine work during the calibration of DKS-96. The program allows a series of measurements specified duration. At the end of the measurements carried out the necessary statistical calculations. Data on the series of measurements carried out can be stored in an external file for later use program "TETRA_Tuner".

The program "TETRA_Tuner" designed to calculate the additional correction factors (K1, K2, K3) used the DKS-96. Calculation of the coefficients is based on the prior series of measurements, either by importing data prepared by the program "TETRA_Tester".

The program "TETRA_Checker" is to set up the DKS-96. It allows you to read, display, record and adjust the coefficients. With "TETRA_Checker" setting can be made to use a certain product algorithm to compute, display the measured value using the selected units. The values ​​of some coefficients can be calculated pre-program "TETRA_Tester", or "TETRA_Tuner".

DWPtest software is intended for debugging of devices that use serial asynchronous communication channel and DiBus protocol (proprietary data exchange protocol for instrumental networks of SPC Doza).
The software allows the following:

• simulate master device – poll the slaves in automatic or non-automatic (manual) mode and receive responses from them;
• simulate slave device – accept requests from master device and, in case of availability of the received packet in the dictionary, respond to a request with corresponding package from the dictionary;
• perform, in automatic mode, batch operations of polling a slave device and display the received data in tabular form; send data entered by the operator to the device.

The file also contains a description of the communication protocol for instrumental networks of SPC Doza.

UMF-2000 software (ver. 1.04) for Win 98/NT/2000/XP